Ganz zn-d9312nha 사용 설명서 - 페이지 6

{카테고리_이름} Ganz zn-d9312nha에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Ganz zn-d9312nha 12 페이지. Zn-d9000 series network mini dome cameras

페이지 인쇄

Running cables on the exterior surface of the ceiling or

wall

To run cables on the exterior surface of the ceiling or wall, use the

following procedure to attach the camera body.

Remove the surface mount cover from the camera body.

Remove the section of the surface

mount cover indicated in the drawing

and then drill a hole through which the

cable is passed.

Bend and remove this area.

Attach the surface mount cover to the

camera body.

Remove the body cover.

Attach the camera body to the ceiling

or wall.

Pass the cable through the holes

you prepared in Step 2 above.

Please use ﬁ xing screws suitable

for the material of the ceiling or wall

when attaching the camera body.

We recommend using screws with

4 mm diameter.

Hold the body cover and turn

the surface mount cover in a

counter-clockwise direction

until you hear a click.

Pass the cable through here.

EG-6

Embedding in the ceiling or wall

Be sure to use the adapter ring when embedding the unit in the

ceiling or wall.

Drilling holes in the ceiling or wall

Use the template included to mark out the position on the ceiling or

wall where you want to install the unit.

Use the template, drill two holes for screws (Screw B) used to attach the

adapter ring. Then, follow the perforations on the template and cut out a

hole to embed the camera body.

Attention

Double check to make sure that the sizes and positions of the holes are

appropriate BEFORE drilling the holes.

Attaching the adapter ring

Attach the adapter ring to the ceiling or wall to

which you want to attach the camera body.

Please use ﬁ xing screws suitable for the mate-

rial of the ceiling or wall when attaching the

camera body. We recommend using screws

with 4 mm diameter.

Connecting the cables

For details of the cable connection, refer to "Connecting the cables"

(page EG-8).

Attaching the camera body

Remove the surface mount cover from

the camera body.

Remove the body cover.