HIKVISION TURBO HD DS-2CE56D8T-VPIT(E) 사용자 설명서 - 페이지 6
{카테고리_이름} HIKVISION TURBO HD DS-2CE56D8T-VPIT(E)에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION TURBO HD DS-2CE56D8T-VPIT(E) 15 페이지. D8t series dome camera
HIKVISION TURBO HD DS-2CE56D8T-VPIT(E)에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지)
페이지 인쇄
3. Loosen the screws on the bubble of the dome
camera to remove the bubble and the black liner.
4. Attach the back box of type I camera/base plate of
type II camera to the ceiling and secure them with
supplied screws.
Type I Camera
Figure 2-2 Attach the Back Box/Base Plate
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall, expansion bolts are required to fix
the camera. For wooden wall, self-tapping screws
are required.
5. Route the cables through the cable hole, or the side
opening.
6. Align the camera with the back box/base plate, and
tighten the screws to secure the camera with the
back box/base plate.
Type I Camera
Figure 2-3 Fix the camera to the Ceiling
7. Connect the corresponding cables, such as power
cord, and video cable.
8. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, adjust the camera according to the figure below
to get an optimum angle.
Type I Camera
0° to 75°
9. Fit the black liner back to the camera and tighten
the screws on the bubble of the dome camera to
finish the installation.
2.2 Ceiling Mounting of Type III Camera
Steps:
Figure 2-1 The Drill Template
0° to 355°
0° to 355°
Figure 2-4 3-Axis Adjustment
Type II Camera
0° to 75°
0° to 355°
0° to 355°