HIKVISION TURBO HD DS-2CE56H0T-ITMF 사용자 설명서 - 페이지 8
{카테고리_이름} HIKVISION TURBO HD DS-2CE56H0T-ITMF에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. HIKVISION TURBO HD DS-2CE56H0T-ITMF 16 페이지. Turbo hd bullet & dome camera
HIKVISION TURBO HD DS-2CE56H0T-ITMF에 대해서도 마찬가지입니다: 사용자 설명서 (17 페이지)
페이지 인쇄
mounting as the reference, when adopting the wall
mounting.
Steps:
1. Disassemble the turret camera by rotating the
camera to align the notch to the clip plate, as shown
in the Figure 2-10.
Figure 2-10 Disassemble the Camera
2. Pry the mounting base to remove the mounting
base from the camera body.
3. Paste the drill template (supplied) to the place
where you want to install the camera.
4. Drill the screw holes according to the drill template,
and the cable hole (optional) on the ceiling.
Note:
Drill the cable hole in the center of the drill template,
when adopting the ceiling outlet to route the cable.
5. Secure the mounting base to the ceiling with the
supplied screws.
Figure 2-12 Fix the Mounting Base to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden
wall/ceiling, self-tapping screws are required.
6. Route the cables through the cable hole, or the side
opening.
7. Secure the camera on the mounting base.
8. Connect the corresponding cables, such as power
cord, and video cable.
9. Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
Figure 2-11 Drill Template
Figure 2-13 Secure the Camera
Clip Plate
Notch
Expansion Bolts
Fixing Screw