decorflame MP-2100 사용 설명서 - 페이지 3

{카테고리_이름} decorflame MP-2100에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. decorflame MP-2100 7 페이지. Electric fireplace heater
decorflame MP-2100에 대해서도 마찬가지입니다: 사용 설명서 (7 페이지)

페이지 인쇄

NOTE: The electric fireplace heater may emit

a slight harmless odor when first turned

on. This is caused by activating the internal

heater components for the first time and

should not occur again.

IMpOrTANT

Please note, when you oPen the

carton carefully check the unit

and make sure there is no damage.

if you have any Problems with

assembling the unit, with how the

various functions work or with

damage or missing Parts Please

call 1-800-459-4409 (9am to 5Pm est)

immediately for service.

note: do not return unit to the

store before calling the toll

free number.

do not disPose of your cartons

until you are comPletely satisfied

with your new firePlace heater.

NOTE: light bulbs may become loose during

shipping. If the flame effect is dim or does not

work, please check that the light bulb or bulbs

are finger tight in socket. See instructions for

replacing the bulb or bulbs.

cAUTION: If you use this heater in conjunction

with a thermal control, a program controller,

a timer or any other device that switches

the heater on automatically, remember to

observe all safety warnings at all times.

The fireplace heater has safety overheat

protection. If the overheat protection trips,

switch off all switch buttons and wait

approximately 5 -10 minutes. It should reset

automatically once the unit cools down.

S A F E T Y I N S T r U c T I O N S

WArNING:

procedures and techniques, if not carefully

followed, will result in damage to the

equipment and will expose the user to the risk

of serious injury, illness or death.

This electric fireplace heater is for use on

120 volts. The cord has a plug as shown at A

in illustration below. An adapter as shown

at c is available for connecting three-blade

grounding-type plugs to two-slot receptacles.

The green grounding plug extending from the

adapter must be connected to a permanent

ground such as a properly grounded outlet

box. The adapter should not be used if a

three-slot grounded receptacle is available.

A 15 AMp circuit is required to operate this

heater. If the breaker trips when the heater is

used then you may need to move the heater to

another location or unplug other appliances

that are on the same circuit. If you require an

extension cord use one that is rated at 1875

watts.