IKEA IUD9500WX4 설치 지침 매뉴얼 - 페이지 14

{카테고리_이름} IKEA IUD9500WX4에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA IUD9500WX4 48 페이지. Undercounter dishwasher
IKEA IUD9500WX4에 대해서도 마찬가지입니다: 사용자 지침 (25 페이지)

페이지 인쇄

Measure height of cabinet opening from underside of countertop

to floor where dishwasher will be installed (you will need to

measure the lowest point on the underside of the countertop and

the highest point on the floor). Refer to "Dishwasher Height

Adjustment Chart" for wheel position and the number of turns

needed.

33%" (86.0 cm)

Removed

All the way up

34" (86,4 cm)

•

NOTE: If the minimum cabinet opening height is less than

34" (86.4 cm), the rear wheels can be removed for additional

clearance. This will allow the dishwasher to fit into a 337/8 '' (86 cm)

high cabinet opening, but the dishwasher will be more difficult to

move. (Measurements are approximate.

Wheels and legs are

preset at the factory for 34W' [87.6 cm].)

Adjust wheels

and legs

Turn both leveler legs to the same height. Put wheels in the

required position determined from "Dishwasher Height

Adjustment Chart."

Built-up floors: If the kitchen floor is higher than the cabinet

opening's floor - for example, the kitchen floor tile does not

extend into the cabinet opening - add shims as needed in the area

shown to bring the dishwasher up to 34" (86.4 cm) below the

countertop.

NOTE: Shims must be securely attached to floor to avoid

movement when the dishwasher is in use.

(O_Ssome

ts_ od®s

Mountin

stud

Mounting

stud

IMPORTANT: Do not scratch the front panel during this

procedure.

Remove the door handle and hardware bag containing the

setscrews and hex key from the cardboard box. Setscrews are

already installed in the handle. Place handle on mounting studs

with the setscrews facing down. Push the door handle tightly

against the door. Insert the short end of the hex key into the

setscrews. Tighten the setscrews V4turn past snug.

Retain hex key with Installation Instructions.