IKEA IUD9500WX4 설치 지침 매뉴얼 - 페이지 16
{카테고리_이름} IKEA IUD9500WX4에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. IKEA IUD9500WX4 48 페이지. Undercounter dishwasher
IKEA IUD9500WX4에 대해서도 마찬가지입니다: 사용자 지침 (25 페이지)
페이지 인쇄
__J Custom
panel
dimensions--
Dishwashers
with
control
panel
on the top
3 screws
per side
outer r
J
Gently set outer panel aside. Lay the customer-supplied
custom
panel face down on a covered, non-scratching
surface.
929/32
i_
(25.2 cm)
p edge
Measure 92%2" (25.2 cm) from top edge and mark a line on the
back of customer-supplied
custom panel. Position the outer panel
on the back of the customer-supplied
custom panel as shown, so
that the top holes in the outer panel are on the line, and both
panels are centered side to side.
Mark pilot
holes
Mark all four hole locations; remove outer panel. Drill 3/32"(2.4 mm)
pilot holes 1/2"(13 mm) deep in customer-supplied
custom panel.
Place the outer panel on the back of the customer-supplied
custom panel; align holes.
Attach outer panel to back of customer-supplied
custom panel
with the four #10-16 x 3/8"hex head screws supplied in the
literature package. Attach the handle. The handle should be
centered on the front of the customer-supplied
custom panel in
the area shown.
IMPORTANT: Screw heads must be flush with back of customer-
supplied custom panel.
?
i
i
R
3 screws
each side
top
edges
Customer-supplied
panel
Attach the panel assembly to the door by reinstalling the three
screws on each side; do not tighten completely. This reinstallation
of the three screws will hold the panel assembly in place on the
door frame.
edges
Customer-supplied
panel
Drill through
these holes
Align the top edge of the customer-supplied
custom panel with
the top of the console.
Drill two 3/32"(2.4 mm) pilot holes 1/2"(13 mm) deep, into the
customer-supplied
custom panel, through the holes in the top
corners on the inner panel, as shown.
16