DecorQuip Cura 피팅 지침

{카테고리_이름} DecorQuip Cura에 대한 피팅 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DecorQuip Cura 2 페이지. Roller blind motor

페이지 인쇄

IMPORTANT SAFETY INSTRUCTIONS

WARNING - FOR PERSONAL SAFETY, IT IS IMPORTANT TO FOLLOW THESE INSTRUCTIONS AT ALL TIMES

SAVE THESE INSTRUCTIONS

Operating Instructions

1. Press the buttons on the remote to operate the blind. *15 Channel Remote Only* Switch channel using the

buttons labelled on the inside page.

2. Do not allow children to play with the remote control of the blind. Keep remote controls away from children.

3. Take appropriate organisational measures for preventing operation of the blind when maintenance, such as

window or wall cleaning, is being carried out in the vicinity.

Maintenance Instructions

1. Replacing/Recharging the Batteries (Cura Motor with Battery Option only)

1.1 Unplug the wire from the motor

1.2 Remove the battery tube from the brackets.

1.3 Unscrew the end of the battery tube and remove and replace the batteries. Ensure that the polarity of

the batteries is correct, and that the end cap of the battery tube is screwed back on tightly.

1.4 Clip the battery tube back into the brackets.

1.5 Please note that if you are using rechargable batteries, you can plug Power Adator code 191662 into

the female part of the wire coming from the battery tube. Leave the Power Adaptor for 6 hours to

recharge the batteries.

2. Caring for your Blind

2.1 Wiping the blind with a soft brush or duster is usually suﬃcient.

2.2 If necessary, Blinds can be wiped clean with a mild detergent and warm water. Leave in the open

position to dry.

2.3 Do not make alterations to the blind, motor or handset.

2.4 Frequently examine the installation for signs of wear or damage to cables. Do not use if a repair

is necessary.

2.5 For an inspection or maintenance of the electrical parts, the internal blind shall be disconnected from

the energy supply in a safe way.

The sound level emitted by the blind is less than or equal to 70 dB(A).

Cura Roller Blind Motor

Fitting Instructions

This procedure can be completed by non-professionals.

Fitting the blind:

This procedure for ﬁtting can be completed by non-professionals. No modiﬁcation of the design or the

conﬁguration of the equipment must not be made without consulting with your local distributor.

1. Decide whether you want to ﬁt face ﬁx or top ﬁx.

2. Position the brackets in where you want to ﬁt the blind.

3. If necessary, mark through the brackets with a pencil, and drill and plug holes for the

screws.

4. Fix the brackets with suitable ﬁxings.. [Please note that screws and other ﬁxings are not

provided.]

5. Take the blind out of all the packaging and insert the pin into the round hole of the idle end bracket.

6. Hook the control end into the slotted bracket making sure that it is ﬁrmly clipped into place.

7. Remove the retaining strip of fabric holding the blind.

Single Channel Remote

Elite Single Channel Remote

Front

Back

Front

Stop

Down

Button

(Can be labelled as 'Setup')

15 Channel / Timer Remote

Elite 15 Channel / Timer Remote

Front

Back

Front

Stop

Switch

Channel

Down

Switch

Channel

Switch

Channel

Button

(Can be labelled as 'Setup')

Single Channel Wall Switch

Back

Stop

Down

Button

Buttons

(press together)

15 Channel / Timer Wall Switch

Back

Down

Switch

Channel

Stop

Switch

Button

Channel

Button

Down