DecorQuip Cura Fitting Instructions

Browse online or download pdf Fitting Instructions for Engine DecorQuip Cura. DecorQuip Cura 2 pages. Roller blind motor

Print Page
IMPORTANT SAFETY INSTRUCTIONS
WARNING - FOR PERSONAL SAFETY, IT IS IMPORTANT TO FOLLOW THESE INSTRUCTIONS AT ALL TIMES
SAVE THESE INSTRUCTIONS
Operating Instructions
1. Press the buttons on the remote to operate the blind. *15 Channel Remote Only* Switch channel using the
buttons labelled on the inside page.
2. Do not allow children to play with the remote control of the blind. Keep remote controls away from children.
3. Take appropriate organisational measures for preventing operation of the blind when maintenance, such as
window or wall cleaning, is being carried out in the vicinity.
Maintenance Instructions
1. Replacing/Recharging the Batteries (Cura Motor with Battery Option only)
1.1 Unplug the wire from the motor
1.2 Remove the battery tube from the brackets.
1.3 Unscrew the end of the battery tube and remove and replace the batteries. Ensure that the polarity of
the batteries is correct, and that the end cap of the battery tube is screwed back on tightly.
1.4 Clip the battery tube back into the brackets.
1.5 Please note that if you are using rechargable batteries, you can plug Power Adator code 191662 into
the female part of the wire coming from the battery tube. Leave the Power Adaptor for 6 hours to
recharge the batteries.
2. Caring for your Blind
2.1 Wiping the blind with a soft brush or duster is usually sufficient.
2.2 If necessary, Blinds can be wiped clean with a mild detergent and warm water. Leave in the open
position to dry.
2.3 Do not make alterations to the blind, motor or handset.
2.4 Frequently examine the installation for signs of wear or damage to cables. Do not use if a repair
is necessary.
2.5 For an inspection or maintenance of the electrical parts, the internal blind shall be disconnected from
the energy supply in a safe way.
The sound level emitted by the blind is less than or equal to 70 dB(A).
Cura Roller Blind Motor
Fitting Instructions
This procedure can be completed by non-professionals.
Fitting the blind:
This procedure for fitting can be completed by non-professionals. No modification of the design or the
configuration of the equipment must not be made without consulting with your local distributor.
1. Decide whether you want to fit face fix or top fix.
2. Position the brackets in where you want to fit the blind.
3. If necessary, mark through the brackets with a pencil, and drill and plug holes for the
screws.
4. Fix the brackets with suitable fixings.. [Please note that screws and other fixings are not
provided.]
5. Take the blind out of all the packaging and insert the pin into the round hole of the idle end bracket.
6. Hook the control end into the slotted bracket making sure that it is firmly clipped into place.
7. Remove the retaining strip of fabric holding the blind.
Single Channel Remote
Elite Single Channel Remote
Front
Back
Front
Up
Stop
Stop
Down
P2
Button
(Can be labelled as 'Setup')
15 Channel / Timer Remote
Elite 15 Channel / Timer Remote
Front
Back
Front
Up
Stop
Stop
Switch
Channel
Down
Switch
Channel
Switch
P2
Channel
Button
(Can be labelled as 'Setup')
Single Channel Wall Switch
Back
Up
Up
Stop
Down
P2
P2
Down
Button
Buttons
(press together)
15 Channel / Timer Wall Switch
Back
Up
Down
Up
Switch
Switch
Channel
Channel
Stop
P2
Switch
Button
Channel
Button
Down
P2