Avantco 178UDD1HCS 사용자 설명서 - 페이지 7
{카테고리_이름} Avantco 178UDD1HCS에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantco 178UDD1HCS 19 페이지. Beer dispensers
Avantco 178UDD1HCS에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지), 사용자 설명서 (19 페이지)
페이지 인쇄
Electrical
•
Please ensure that the required voltage is being supplied at all times.
•
The unit should be plugged into a grounded and properly-sized electrical outlet with appropriate
over-current projection. NEVER USE AN ADAPTER PLUG! Please refer to the electrical requirements
on the unit's nameplate.
•
This unit should have its own dedicated outlet.
•
Do not use extention cords.
•
Do not unplug your cooler by pulling on the power cord. Grip the plug firmly and pull straight out
from the outlet.
•
Ensure the unit is not resting on or against the electrical cord.
•
If the unit is not in use for a long period of time, please unplug the unit from the outlet.
•
To avoid shock and fire hazards, do not plug in or unplug the unit with wet hands.
•
After unplugging the unit, wait at least 10 minutes before plugging it back in. Failure to do so could
cause damage to the compressor.
Installing Draft Tower
2
3
User Manual
Beer Dispensers
1.
Connect beer line connector to keg coupler.
2. Place rubber washer over draft arm mounting holes
in cabinet.
3. Put beer line connector down through hole.
4. Secure draft arm with four screws.
5. Insert air hose in draft arm, being careful not to
disturb insulation.
6. Remove top cover of draft arm and attach air hose
clip to the insulating sleeve at the top of the draft arm.
This will assure that the hose remains in the proper
place at all times, which will keep the beer faucet cold.
1
7.
Replace top cover.
8. Screw the handle onto the beer faucet.
4
5
6
7
www.AvantcoRefrigeration.com
8
7