Cerasonar Sub Series 설치 지침 - 페이지 2
{카테고리_이름} Cerasonar Sub Series에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Cerasonar Sub Series 2 페이지.
페이지 인쇄cerasonar sub series
Check the construction for vibration
noise, make sure the cavity has
proper insulation. Prepare the wall
or ceiling to fit in the speaker.
Fill in plaster, we HIGHLY
recommand to use a fl exible
filler, e.g. Knauf Unifl ott or
Ardex 828
Strip the wire by 10 mm.
Connect the speaker cable
to the speaker, be aware of
the polarity
Use mesh tape in the
plastering process
Installation instructions
invisible subwoofer for all cerasonar speakers
Insert the speaker, make sure
there is no strain between the
underlying insulation and speaker.
Screw through all pre-drilled
holes. The heads of the screws
should penetrate about 1 mm into
the panel material.
ATTENTION: Test the speaker!
Up to 2mm of plaster can be ap-
plied, thus, Q3 and Q4 wall /ceiling
quality levels are easily possible.
ATTENTION: Before using the
speaker, let the plaster dry off More
information about the installation
process in our FAQ section.