ENGLISH
Problem and alarm code
The appliance does not fill with water.
The display shows
The appliance does not drain the wa-
ter.
The display shows
The anti-flood device is on.
The display shows
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
The washing and drying results are not satisfactory
Problem
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry wa-
ter drops on glasses and
dishes.
The dishes are wet.
Refer to "Hints and tips" for
other possible causes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water sup-
.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not
• Make sure that the inlet hose has no kinks or
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or
.
• Close the water tap and contact an Authorised
.
• The release quantity of rinse aid is too much. Adjust
the rinse aid selector to a lower position.
• The quantity of detergent is too much.
• The released quantity of rinse aid is not sufficient. Ad-
just the rinse aid selector to a higher position.
• The quality of the rinse aid can be the cause.
• The programme does not have a drying phase or has
a drying phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• The quality of the multi-tablets can be the cause. Try a
different brand or activate the rinse aid dispenser and
use rinse aid and multi-tablets together.
Possible solution
ply is not too low. For this information, contact
your local water authority.
clogged. Clean the filter.
bends.
bends.
Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
Possible solution
17
페이지 인쇄