BERNHARDT design a.k.a. C-base 사용 설명서 - 페이지 7

{카테고리_이름} BERNHARDT design a.k.a. C-base에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. BERNHARDT design a.k.a. C-base 20 페이지.

Step 18

Workwall mounted items attach to the Workwall by locking

the Workwall rails into a mating extrusion on the mounted

component. Simply lift the mounting item to the desired

attachment rail and rotate upward to a 45° angle. The

mating extrusion should slide into the Workwall rail. Slowly

rotate the mounting item back to level while keeping

pressure toward the Workwall.

Make sure to check that the full length of the mounting

item is engaged into the Workwall Rail.

Step 19

Once the component is hung make sure that the two

extrusions are fully engaged. If there are any dips in the

Workwall Structure it may cause the extrusions to not fully

engage.

This is a critical step – please verify.

Step 20

This step can be done before or after an overhead is

installed.

To install the LED Light Rail, scribe a line 6" back from the

front edge of the shelf or overhead. Space the Light Rail

Mounting Brackets evenly over the entire length of the

Light Rail. Attach the Light Rail Mounts following the

instructions printed on each one.

September 2012