GAPOSA XQ5 프로그래밍 퀵 매뉴얼

{카테고리_이름} GAPOSA XQ5에 대한 프로그래밍 퀵 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAPOSA XQ5 3 페이지.

페이지 인쇄

CONNECT POWER TO THE MOTOR

PROGRAMMING A TRANSMITTER

1 Press and hold the SYNC button on the back of the transmitter

or the white button on the head of the motor until the motor

starts moving

2 Check the motor rotation (UP or DoWN) then release the SYNC

button or the white button (the motor now stops)

3 Within 5 seconds, press the corresponding button (UP if the

motor turns upwards or DoWN if the motor turns downwards.)

This will set the direction of the motor. If the incorrect button is

pressed, the controls will be reversed. To fix, see Sec. 3.

Transmitter is now programmed

ADDING A NEW TRANSMITTER

When adding new transmitters, begin with the motor position

somewhere inbetween the two limits. This allows the motor to

have room to move, and allows the direction that the motor moves

to be discernible.

1 Press and hold the SYNC button on the back of a transmitter

ALREADY paired until the motor starts moving in one direction

2 Check the motor rotation (UP or DoWN) then release the SYNC

button (the motor now stops)

3 Within 5 seconds, press the corresponding button (UP if the

motor turns upwards or DoWN if the motor turns downwards)

on the NEW transmitter being added. This will set the direction

of the motor.

Additional transmitter is now added

CHECKING / CHANGING DIRECTION

To check the direction, press the UP or DoWN button. The motor

will go UP or DoWN accordingly, if the direction needs to be

changed:

1 Press and hold the SYNC button on the back of transmitter until

the motor starts moving

2 Press the STOP button; the motor makes a brief jog. The direction

of the motor has been reversed

IMPORTANT: the change of direction procedure must be

performed before initiating the limit setting procedure,

otherwise limits will need to be reset

Programming Quick Guide

The buttons shown on the left are used to program the transmitters and specific channels.

The programing button's (buttons 4 and 5) locations can be placed differently depending

on the transmitter model. Shown in this guide is the Emitto Slim line transmitter.

UP (1)

SToP (2)

DoWN (3) the rolling shade/awning moves down

(Sec. 1)

(Sec. 2)

(Sec. 3)

the rolling shade/awning moves up

the rolling shade/awning stops

OFF

OPTION 1

SYNC (4)

program the transmitter

LIMIT (5)

set limits

OPTION 2