GAPOSA M1A 참조 매뉴얼 - 페이지 8

{카테고리_이름} GAPOSA M1A에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GAPOSA M1A 11 페이지. Safety brake
GAPOSA M1A에 대해서도 마찬가지입니다: 참조 매뉴얼 (14 페이지)

5. Insert the shaft support pin (with key or square in case of M1A and M2A) into the

safety brake hole smoothly; eventually check the alignment between the safety brake

hole, on one side, and the output shaft on the other side;

6. Avoid a snapping working of the shutter since it might cause the intervention of the

safety brake. A well-built side slide and good profiles assure a regular working of the

device;

7. Connect the safety brake electrical cable (complete with micro switch and NC contact)

to the STOP control in the motor control unit;

During installation, in order to avoid bad performances of the safety brake, do not

tamper the screws and the relative nuts on the central body; GAPOSA srl is not

responsible for damages caused by a wrong installation or an improper use.

TESTING INSTRUCTIONS

The testing process of the safety brake consists of:

1. An accurate check of a perfect installation, by making sure that all the fastening screws

of the base and of the safety brake are provided with suitable washers (preferably self-

locking washers) and perfectly tightened, Make also sure that the safety brake has not

been unduly opened.

2. A check of the safety brake regular working, while the shutter is rotating. Since it is

not possible to simulate a breakage in the transmission, you can make sure of the

good working of the safety brake by listening to the linking caused by the adjustment

of internal components. If this is clearly heard the safety brake has passed the working

test.

3. A check of the electrical continuity at the extremity of the micro-switch thread.

IMPORTANT: CHECK THAT THE SAFETY BRAKE HAS NOT UNDERGONE PREVIOUS

TESTS AND STRONG STRESSES.