Makita 3606 사용 설명서 - 페이지 6

{카테고리_이름} Makita 3606에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 3606 17 페이지. Makita 3606 plunge router: specifications
Makita 3606에 대해서도 마찬가지입니다: 부품 분석 (2 페이지)

페이지 인쇄

FUNCTIONAL

DESCRIPTION

1. Scale ring

2. Clamp screw

1. Switch lever

CAUTION:

•

Always be sure that the tool is switched off and

unplugged before adjusting or checking function on the

tool.

Adjusting the depth of cut

003651

Place the tool on a flat surface. Turn the scale ring until it

makes contact with the base. Loosen the clamp screw. Turn

the scale ring until the bit just touches the flat surface.

Tighten the clamp screw.

Place the tool on its side and turn the scale ring counter-

clockwise (when viewing the tool from the top) until the

desired depth of cut is obtained. One full turn of the scale

ring is equal to 1/4" change in depth setting. Loosen the

clamp screw and move the tool base until it makes contact

with the scale ring. Then tighten the clamp screw securely.

CAUTION:

•

Since excessive cutting may cause overload of the motor

or difficulty in controlling the tool, the depth of cut should

not be more than 15 mm (9/16") at a pass when cutting

grooves with a 6 mm (1/4") diameter bit.

NOTE:

•

When cutting grooves with a 20 mm (13/16") diameter

bit, the depth of cut should not be more than 5 mm

(3/16") at a pass.

When you wish to cut grooves more than 15 mm (9/16")

deep with a 6 mm (1/4") diameter bit or more than 5 mm

(3/16") deep with a 20 mm (13/16") diameter bit, make

several passes with progressively deeper bit settings.

Switch action

003659

CAUTION:

•

Before plugging in the tool, always check to see that the

tool is switched off.

•

Switch can be locked in "ON" position for ease of

operator comfort during extended use. Apply caution

when locking tool in "ON" position and maintain firm

grasp on tool.

•

Make sure that the shaft lock is released before the

switch is turned on.