CORNING Lambda EliteMax 빠른 시작 매뉴얼

{카테고리_이름} CORNING Lambda EliteMax에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING Lambda EliteMax 5 페이지. Semi-automated benchtop pipettor

페이지 인쇄

Corning

Lambda

Semi-automated Benchtop Pipettor

Quick Start Guide

For the complete Corning Lambda EliteMax Benchtop Pipettor Instruction

Manual (CLS-AN-671DOC), visit www.corning.com/lifesciences.

Instrument Identification

Liquid Head

Touch Screen

Controller

Instrument Deck

Manually

Operated

Tip Ejector

Single-

channel

Head

Unboxing

Tools needed: Phillips and flat head screwdrivers, 2 mm Allen

wrench (provided), hammer, and needle-nose pliers.

Pry open top of box with the flat head screwdriver.

◗

Remove the screws holding down the deck plate with the

◗

Phillips head screwdriver.

Remove the unit from the box, lifting from the bottom of the

◗

deck plate, and place on the benchtop.

Be sure to remove the holding bracket prior to use. The holding

◗

bracket is located next to the yellow warning label and can be

removed using the Allen wrench provided.

™

EliteMax

Disposable Tips and

Plates (not included)

Multi-

channel

Head

Installation

1. Connect the Touch Screen Controller cable into the rear panel

of the Corning Lambda EliteMax Benchtop Pipettor.

2. Connect the round connector of the universal external power

supply to the rear panel of the instrument. Push in firmly until

you feel it click into position.

3. Connect the AC power cord to the universal external power

supply and then to the AC wall power receptacle. The AC

power receptacle should be able to supply approx. 300W and

MUST be grounded to a true earth ground.

4. Power up the unit by rocking the Reset/Off switch located in

the back of the Corning Lambda EliteMax Benchtop Pipettor

to the Reset position. The instrument should boot up, and the

home screen will appear in a few seconds.