Makita 3707F 사용 설명서 - 페이지 7

{카테고리_이름} Makita 3707F에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 3707F 16 페이지. Trimmer
Makita 3707F에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용 설명서 (17 페이지), 사용 설명서 (10 페이지), 사용 설명서 (13 페이지)

페이지 인쇄

1. Screws

2. Base protector

3. Screwdriver

10mm(3/8")

1. Straight bit

2. Base

3. Templet

4. Distance (X)

5. Workpiece

6. Templet guide 10

Templet guide

001703

The templet guide provides a sleeve through which the bit passes, allowing

use of the trimmer with templet patterns.

Loosen the screws and remove the base protector. Place the templet guide on

001704

the base and replace the base protector. Then secure the base protector by

tightening the screws.

Secure the templet to the workpiece. Place the tool on the templet and move

001988

the tool with the templet guide sliding along the side of the templet.

NOTE:

•

The workpiece will be cut a slightly different size from the templet. Allow

for the distance (X) between the router bit and the outside of the templet

guide. The distance (X) can be calculated by using the following

equation:

Distance (X) = (outside diameter of the templet guide - router bit diameter) / 2

Straight guide (Accessory)

001706

The straight guide is effectively used for straight cuts when chamfering or

grooving.