Makita 3901 사용 설명서 - 페이지 5
{카테고리_이름} Makita 3901에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 3901 12 페이지. 12-1/4" planer, blade sharpener, plate joiner, chain mortiser, blower, heat gun
Makita 3901에 대해서도 마찬가지입니다: 브로셔 (1 페이지), 사용 설명서 (16 페이지), 사용 설명서 (17 페이지)
페이지 인쇄
21. Do not use the tool with damaged guards.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this
instruction manual may cause serious personal
injury.
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Adjusting the depth of cut
004574
6 cutting depths can be preset according to the size of
biscuit to be used or if trimming the wall or ceiling panels
as explained later. Rotate the stopper until the pointer
points to the appropriate size marked on the stopper.
Refer to the table below for the correspondence
between the sizes marked on the stopper and the biscuit
size. Fine adjustments to the cutting depth can be made
by turning the adjusting screw after loosening the hex
nut. This may become necessary after the blade has
been resharpened a few times.
Size on stopper
0
Biscuit size
0
Depth of cut
8 mm
10 mm 12.3 mm 13 mm 14.7 mm 20 mm
006424
1. Pointer
1
2. Stopper
3. Adjusting screw
2
3
10
20
S
D
10
20
-
-
Angle guide
1
2
004575
004576
The angle guide can be moved up and down to adjust
the position of the blade in relation to the top of the
workpiece.
To adjust the angle guide height, loosen the lock lever
down and rotate the knob until the pointer points to the
desired scale graduation marked on the angle guide.
Then tighten the lock lever up to secure the angle guide.
The scale on the angle guide indicates the distance from
the top of the workpiece to the center of the blade
thickness.
Fence
1
MAX
-
004577
3
10 mm (0.4")
10 mm (0.4")
004578
5
5
4
3
1
2
3
4
2
3
1
2
4
5
1. Lock lever
2. Angle guide
3. Knob
4. Scale
5. Pointer
1. Knob
2. Down
3. Up
4. Center of blade
thickness
1. Fence
2. Lock lever
3. Angle scale
1. Lock lever
2. Pointer
3. Angle scale
4. Center of blade
thickness
5. Base