CORNING Matribot Bioprinter 사용 설명서 - 페이지 2
{카테고리_이름} CORNING Matribot Bioprinter에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING Matribot Bioprinter 8 페이지. Demonstration equipment
CORNING Matribot Bioprinter에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)
페이지 인쇄
Unpacking the Corning® Matribot® Bioprinter
Follow these steps to unpack the Corning Matribot Bioprinter.
Do not attempt to unpack the Corning Matribot Bioprinter without reviewing the procedures below. Doing so risks personal
injury and equipment damage.
Always use a minimum of two people to unpack and move the Corning Matribot Bioprinter.
The Corning Matribot Bioprinter should never be placed on wet, damp, moist, or humid surfaces.
Do not force or tear anything during the unpacking or setup process as this may irreversibly damage your Corning Matribot
Bioprinter.
Position the system to ensure the user has fast access to the power cable or that the system is run through an emergency
disconnect when an emergency stop may be required.
The device must be connected to a power outlet with protective grounding.
1. Clear a sturdy table benchtop and floor space of at least 2 x 3 feet
(0.6 x 0.9 meters).
2. Place the box on the floor and open it.
3. Save boxes to return the unit after the demo is completed. A return shipping label is included in the consumables supply box.
4. Remove the two loose item boxes.
5. Review the contents of the two boxes to ensure that you have received all of the items listed below.
• Electrical supply box contains:
[1x] 24V Power supply
[2x] Power cord
[1x] USB cable A male to B male 1.83m
[1x] SD card, 32GB, SDHC
[1x] 384-well microplate nozzle thermal insulator
[1x] Standard nozzle thermal insulator
[1x] Surface probe
[1x] Toolkit for preventive maintenance (3 hex keys)
• Consumables supply box contains:
[5x] 3 mL syringes, sterile
[10x] High precision conical bioprinting nozzles, 22G (non-sterile)
[10x] High precision conical bioprinting nozzles, 25G (non-sterile)
[1x] Glass Petri dish
[1x] Return shipping label
1