CORNING Matribot Bioprinter 사용 설명서 - 페이지 6

{카테고리_이름} CORNING Matribot Bioprinter에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING Matribot Bioprinter 8 페이지. Demonstration equipment
CORNING Matribot Bioprinter에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지)

페이지 인쇄

4. Lift the printbed support located at the back

of the printer to raise the printbed slightly

higher than required to fit the lower inner

foam insert. Push the lower inner foam

insert from the front of the printer to slide it

under the printbed. Lower the printbed onto

the foam by gently pushing on the printbed

support located at the back of the printbed.

5. Confirm that the thermal insulator has been

removed from the cooling block to prevent

damaging the thermal insulator. Gently

move the printhead to the center of the

unit and slide the middle inner foam insert

from the front as shown. Align the lower

and middle foam inserts with each other by

adjusting the position of the printhead.

6. Make sure the syringe plunger is straight

so it is aligned with the slot in the top

foam and hold the printhead cable out of

the way, ensuring it is aligned with the

cable cutout in the back of the foam insert.

Insert the top inner foam insert from the

top of the unit as shown.

7. Place the Corning® Matribot® bioprinter inside the plastic bag, ensuring that the

bioprinter is completely covered.