Makita 4304 사용 설명서 - 페이지 11
{카테고리_이름} Makita 4304에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 4304 20 페이지. Variable speed
Makita 4304에 대해서도 마찬가지입니다: 사용자 설명서 (8 페이지)
cutouts
Cutouts can be made with either of two methods A or
B.
A) Boring a starting hole:
For internal cutouts without a lead-in cut from an edge, predrill starting hole more
than 12 mm (15/32") in diameter. Insert the blade into this hole and hold the tool
firmly against the workpiece to start your cut.
/
For 4304
Starting hole
A
/
p
Starting hole
B)
Plung cutting
You need not bore a starting hole or make a lead-in cut if you carefully do as follows:
1. Tilt the tool up on the front edge of the base, with the blade point positioned just
2. Apply firm pressure to the tool
so that the front edge of the base will not move
3.
As
the blade slices into the workpiece, slowly lower the base of the tool down onto
4. Complete the cut in the normal manner.
above the workpiece surface.
when you switch on the tool and gently lower the back end of the tool slowly.
the workpiece surface.
For 4304
~
For 4305
11