Garage Tek GT1006 설치 및 사용 설명서 - 페이지 4
{카테고리_이름} Garage Tek GT1006에 대한 설치 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Garage Tek GT1006 6 페이지. Tall cabinet
페이지 인쇄J
B
i
STEP 5: INSTALL DOOR BIN, SHELVES AND LOGO
A.
SNAP THE DOOR BIN (J), QTY 1, IN THE TRACKS ON THE INSIDE OF THE DOOR AT ELEVATION WHERE SHELF WILL
NOT BE LOCATED
B.
SNAP THE SHELF STRIPS (i) X12 , INTO THE VERTICAL TRACKS AROUND THE INSIDE OF THE CABINET. THERE ARE X4
STRIPS PER LOCATION. THE STRIPS WITH THE ARCHED HOOD ARE IN THE BACK OF THE CABINET AND THE FLAT
TOPPED STRIPS ARE ON THE SIDES. PLACE THE SHELVES (C) X3, ON THE STRIP HOLDER STRIPS (i).
C.
APPLY THE GT LOGO (P), X1, ON THE LOCATION SHOWN.
ADDITIONAL SHELVES (C), STRIPS (i) AND DOOR BINS (J) CAN BE PURCHASED AS ADDITIONAL ACCESSORIES
CABINET SHOWN WITH OPENED DOORS
TOP
DOOR
DRILL (2)
3/16" HOLES
STEP 6: INSTALL HANDLE SET
A.
OPEN BOTH DOORS AND DRILL (2) 3/16" HOLES THROUGH THE DOORS AS INDICATED ABOVE.
B.
ORIENTATE THE LEFT & RIGHT HANDLES (G) AS SHOWN WITH THE PADLOCK HOLES IN-LINE ON EACH HANDLE AND
ARE AT THE BOTTOM OF THE HANDLE SET.
C.
DO NOT USE A POWER TOOL. HAND SCREW AND SECURE THE HANDLE WITH A 1 1/2" SCREW (H) & 7/8" LONG
SCREW (K) PER SIDE SIDE.
D.
ADJUST THE HANDLES TO BE IN-LINE AND LEVEL BY LOOSENING AND RETIGHTENING THE SCREWS AS NEEDED.
TOP
DOOR
DRILL (2)
3/16" HOLES
P
C
C
i
i
G
PADLOCK
HOLES
PAGE 4 OF 6 REV SEPT 2021