Makita 4326M 사용 설명서 - 페이지 5
{카테고리_이름} Makita 4326M에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 4326M 13 페이지. Jig saw
Makita 4326M에 대해서도 마찬가지입니다: 사양 (2 페이지), 기술 정보 (7 페이지)
페이지 인쇄
Switch action
1
► 1 . Switch trigger 2. Lock button
CAUTION:
•
Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
For continuous operation, pull the switch trigger and
then push in the lock button.
To stop the tool from the locked position, pull the switch
trigger fully, then release it.
Speed adjusting dial (For models
4327/4327M/4328/4329)
1
► 1 . Speed adjusting dial
The tool speed can be infinitely adjusted between 500
and 3,100 strokes per minute by turning the adjusting
dial. Higher speed is obtained when the dial is turned in
the direction of number 6; lower speed is obtained when
it is turned in the direction of number 1.
Refer to the table to select the proper speed for the
workpiece to be cut. However, the appropriate speed
may differ with the type or thickness of the workpiece. In
general, higher speeds will allow you to cut workpieces
faster but the service life of the blade will be reduced.
2
CAUTION:
•
•
ASSEMBLY
CAUTION:
•
Installing or removing saw blade
1
2
3
► 1 . Blade holder 2. Bolt 3. Hex wrench
CAUTION:
•
•
•
•
•
5 ENGLISH
Workpiece to be cut
Wood
Mild steel
Stainless steel
Aluminum
Plastics
If the tool is operated continuously at low
speeds for a long time, the motor will get over-
loaded and heated up.
The speed adjusting dial can be turned only as far
as 6 and back to 1. Do not force it past 6 or 1, or
the speed adjusting function may no longer work.
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Always clean out all chips or foreign matter
adhering to the blade and/or blade holder.
Failure to do so may cause insufficient tighten-
ing of the blade, resulting in a serious personal
injury.
Do not touch the blade or the workpiece imme-
diately after operation; they may be extremely
hot and could burn your skin.
Always secure the blade firmly. Insufficient tight-
ening of the blade may cause blade breakage or
serious personal injury.
Use only B type blades. Using blades other than
B type blades causes insufficient tightening of
the blade, resulting in a serious personal injury.
(For models 4326/4327/4328/4329)
Use only Makita type blades. Using blades other
than Makita type blades causes insufficient
tightening of the blade, resulting in a serious
personal injury. (For models 4326M/4327M)
Number on adjusting dial
5 - 6
3 - 6
3 - 4
3 - 6
1 - 4