Makita 4327 사용 설명서 - 페이지 10

{카테고리_이름} Makita 4327에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 4327 13 페이지. Jig saw
Makita 4327에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 사양 (2 페이지), 사용 설명서 (13 페이지), 기술 정보 (7 페이지), 사용 설명서 (13 페이지)

페이지 인쇄

1. Specifications

Steel base type

1. Rip fence (Guide rule)

Aluminum base type

1. Rip fence (Guide rule)

When cutting circles or arcs of 170 mm or less in

radius, install the rip fence as follows.

Insert the rip fence into the rectangular hole on the

side of the base with the fence guide facing up.

Insert the circular guide pin through either of the

two holes on the fence guide. Screw the threaded

knob onto the pin to secure the pin.

Now slide the rip fence to the desired cutting

radius, and tighten the bolt to secure it in place.

Then move the base all the way forward.

NOTE:

•

Always use blades No. B-17, B-18, B-26 or

B-27 when cutting circles or arcs. (For models

4326/4327/4328/4329)

•

Always use Makita type blades No.6, No.7,

No.16, No.17, when cutting circles or arcs. (For

models 4326M/4327M)

Anti-splintering device for steel

base (optional accessory)

► 1 . Anti-splintering device 2. Protrusions

For splinter-free cuts, the anti-splintering device can

be used. To install the anti-splintering device, move the

base all the way forward and insert it between the two

protrusions of the base.

NOTE:

•

The anti-splintering device cannot be used when

making bevel cuts.

Anti-splintering device for aluminum

base (Optional accessory)

► 1 . Anti-splintering device 2. Aluminum base

For splinter-free cuts, the anti-splintering device can

be used. To install the anti-splintering device, move the

tool base all the way forward and fit it from the back

of tool base. When you use the cover plate, install the

anti-splintering device onto the cover plate.

CAUTION:

•

The anti-splintering device cannot be used when

making bevel cuts.

10 ENGLISH