Makita 4327 Instrukcja obsługi - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 4327. Makita 4327 13 stron. Jig saw
Również dla Makita 4327: Instrukcja obsługi (13 strony), Specyfikacje (2 strony), Instrukcja obsługi (13 strony), Informacje techniczne (7 strony), Instrukcja obsługi (13 strony)
Drukuj stronę
Steel base type
1
1. Rip fence (Guide rule)
Aluminum base type
1
1. Rip fence (Guide rule)
When cutting circles or arcs of 170 mm or less in
radius, install the rip fence as follows.
Insert the rip fence into the rectangular hole on the
side of the base with the fence guide facing up.
Insert the circular guide pin through either of the
two holes on the fence guide. Screw the threaded
knob onto the pin to secure the pin.
Now slide the rip fence to the desired cutting
radius, and tighten the bolt to secure it in place.
Then move the base all the way forward.
NOTE:
•
Always use blades No. B-17, B-18, B-26 or
B-27 when cutting circles or arcs. (For models
4326/4327/4328/4329)
•
Always use Makita type blades No.6, No.7,
No.16, No.17, when cutting circles or arcs. (For
models 4326M/4327M)
Anti-splintering device for steel
base (optional accessory)
1
► 1 . Anti-splintering device 2. Protrusions
For splinter-free cuts, the anti-splintering device can
be used. To install the anti-splintering device, move the
base all the way forward and insert it between the two
protrusions of the base.
NOTE:
•
The anti-splintering device cannot be used when
making bevel cuts.
Anti-splintering device for aluminum
base (Optional accessory)
► 1 . Anti-splintering device 2. Aluminum base
For splinter-free cuts, the anti-splintering device can
be used. To install the anti-splintering device, move the
tool base all the way forward and fit it from the back
of tool base. When you use the cover plate, install the
anti-splintering device onto the cover plate.
CAUTION:
•
The anti-splintering device cannot be used when
making bevel cuts.
10 ENGLISH
2
2
1