GarageAce ET30 사용 설명서 - 페이지 11

{카테고리_이름} GarageAce ET30에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GarageAce ET30 18 페이지. Rolling garage door opener

4.2 Door travel limit Setting

4.2.1 Pull down the manual release lever, the door

operator is under manual mode.

4.2.2 Open the door by hand until the door

touches the upper door stop. (see Fig.7)

Close the door by hand until the door touches

the ground . (see Fig.8)

4.2.3 Push up the manual release lever, the door

operator is now under electric mode.

4.2.4 Press 'SET' button and hold on until LED displays

figure '1' , then adjust the up limit by pressing the

'up' button. Fine-tune using 'up' or 'down' button to

determine the final up limit position, then press

'SET' button to confirm. The display will now show a

'2' automatically.

Adjust the down limit by pressing 'down' button.

Fine-tuning 'up' or 'down' button to determine the

final down limit position, then press 'SET' button.

The opener will operate a cycle automatically to

remember the limit positions and the opening &

closing force. If completed correctly, a 'half 11' will

be displayed on the control panel indicating that the

unit is in standby mode. If this does not occur then

repeat the steps above.

Setting processes：

Press 'SET' button

Press 'SET' button to confirm the setting

Display '1'

Press 'UP' or 'DOWN' button to adjust the opening height

Display '2'

Press 'DOWN' or 'UP' button to adjust the closing height