GarageAce ET30 사용 설명서 - 페이지 12

{카테고리_이름} GarageAce ET30에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GarageAce ET30 18 페이지. Rolling garage door opener

4.2.5 Press the RED O/S/C button at the bottom of door operator or K button (FIG.9), confirm the up limit and

down limit are correct. If not, please re-set the travel limit according to above processes until the limits are

correct.

4.3 CODING TRANSMITTER

4.3.1 The operator should be under standby mode when coding remotes. Press 'SET' button until the coding

light turns on and the operator is under remote learning mode. Press any one button two times on the remote,

the coding light will extinguish. The remote has been coded successfully. Use the same method to code

multiple remotes. Up to 20 can be stored at any one time.

Press 'CODE' button

4.3.2 Deleting remotes： Press the code button over 8 seconds until display shows C, then it will be under

standby mode. All stores remotes are now deleted.

Press 'CODE' button over 8 seconds

Press any one

Red light turn on

button 2 times

Display C

Light flashes

Under standby mode

Light turn off

Coding finished