GarageAce R3 설치 지침 매뉴얼 - 페이지 14

{카테고리_이름} GarageAce R3에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GarageAce R3 20 페이지. Roller garage door opener

Please confirm the photocells are well connection and programmed. Please check if the door will be

automatically reversed when encountering an obstacle during door closing.

4.5.3 Canceling the photocell function:

Press 'DOWN' button and hold on until the LED displays 'H' , press 'DOWN' button the LED displays 11', to

cancel this function, press 'SET' to confirm. The default is close for this function.

to cancel this function. When setting is finished,

Press 'DOWN' button

Display 'H'

Press 'DOWN' button

Display '11'

Press 'SET' to confirm

WARNING: Close the photo beam function when not utilizing photo beam sensor.

4.6 Auto close setting:

Press 'UP' button and hold on until the LED displays '-'. Press 'up' button once, the auto-close time will

increase by 1 minute, the maximum time is 9 minutes. Press 'down' button the auto-close time decrease by 1

minute. The auto-close function will be turned off when LED displays 0. Press 'SET' button to confirm.

The default setting for this function is 0 (off).

Display '-'

Press 'UP' button

Press 'UP' or 'DOWN' button to choose the close time

The minute from 1 to 9

Press 'SET' to confirm

NOTE：The auto close is only available when door is at its full open position.

When using auto close mode, a photo electric beam must be fitted correctly

and tested for operation at regular intervals.