Makita 4350CT 기술 정보 - 페이지 3

{카테고리_이름} Makita 4350CT에 대한 기술 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 4350CT 14 페이지. Jig saw
Makita 4350CT에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용 설명서 (13 페이지), 사용 설명서 (13 페이지), 사용 설명서 (13 페이지)

페이지 인쇄

epair

[2] Disassembling Tool opener

1. Remove M5x18 Hex socket head bolt. Base is separated from product. (Fig. 1)

2. Remove M4 + Pan head screw. Tool opener and Torsion spring 6 are separated. (Fig. 2)

Fig. 1

M5x18 Hex

socket head bolt

[3] Assembling tool opener

1. Install Torsion spring 6 into the depression on Gear housing cover around Tool opener hinge portion, and then fasten

Tool opener to Gear housing cover with M4 + Pan head screw.

2. Turn the tail of Torsion spring 6 clockwise using thin flat screwdriver to set it in place. (Fig. 3)

Fig. 3

Viewed from Blade holder side

Gear housing

Blade holder

[4] Disassembling Handle section

1. Separate Handle R from Housing L by the following steps.

(1) Remove Tapping screws as illustrated in Fig. 4.

(2) Gently lift up the 4x50 Tapping screw installation side of Handle R with slotted screwdriver to remove the hooks of

Handles L and R from the notch of Motor housing. (Fig. 5)

Note: Take care not to break the hooks, the protrusion and the depressions when disassembling.

2. LED circuit (only for 4350FCT) and Safety wire can be removed together. As for removal of Safety wire, open Tool

opener and remove both tails of Safety wire from the holes of Gear housing cover behind Handles L and R.

Fig. 4

4x18 Tapping screw

Tool opener

Base

Tool opener

The tail of

torsion spring 6

Gear housing cover

4350T, 4350CT: 4x18 Tapping screw

4350FCT: 4x40 Tapping screw

4x50 Tapping screw

(Refer to Fig. 5.)

Safety wire

Fig. 2

Torsion spring 6

Tool opener

M4 + Pan head screw

Tool opener hinge portion

Fig. 5

Notch of Motor housing

Slotted screwdriver

P 3 / 14

M4 + Pan head screw

Hook of Handle L

Hook of

Handle R

4x50 Tapping screw

installation hole