Makita 4350CT 기술 정보 - 페이지 4
{카테고리_이름} Makita 4350CT에 대한 기술 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 4350CT 14 페이지. Jig saw
Makita 4350CT에 대해서도 마찬가지입니다: 사양 (2 페이지), 사용 설명서 (13 페이지), 사용 설명서 (13 페이지), 사용 설명서 (13 페이지)
페이지 인쇄
R
epair
[5] Disassembling Gear housing cover section
1. After separating Safety wire from Gear housing cover, remove four CT 4x16 Tapping screws.
Gear housing cover and Packing are separated from Gear housing with Motor housing as illustrated in Fig. 6.
Fig. 6
CT 4x16 Tapping screws
2. Remove Stop ring E-3 with slotted screwdriver.
Push Slider to the lower dead point. (Fig. 7)
Fig. 7
Inside of Gear housing cover
Slider
Pin 4
Rod
3. Slide Pin 4 in order to disconnect Rod with Slider. And then, pull out Rod from Gear housing cover.
Separate Linear guides from Gear housing by removing four M4x10 Pan head screws.
Pin 4, Slider and Leaf spring are disassembled from Gear housing cover. (Fig. 8)
Fig. 8
Linear guides
Slider
Pin 4
Note: Pay attention to the direction of Leaf spring illustrated above when reassembling.
Gear housing cover
Packing
Stop ring E-3
Rod
Gear housing cover
Rod
Gear housing
Slider in the lower
dead point
Linear guides
Leaf spring
Slider
Pin 4
M4x10 Pan head
screws
P 4 / 14