Makita 4350FCT 기술 정보 - 페이지 9

{카테고리_이름} Makita 4350FCT에 대한 기술 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 4350FCT 14 페이지. Jig saw
Makita 4350FCT에 대해서도 마찬가지입니다: 사양 (2 페이지), 부품 분석 (3 페이지), 사용 설명서 (13 페이지), 사용 설명서 (13 페이지), 사용 설명서 (13 페이지)

페이지 인쇄

epair

[10] Assembling parts in Gear housing

1. Pass the shaft of Gear housing through Flat washer 8. (Fig. 26)

2. After assembling Seal plate to Push plate, pass the shaft of Gear housing through Push plate with Seal plate. (Fig. 27)

3. Lubricate the parts with referring to [1] Lubrication in page 2.

4. Pass the shaft of Gear housing through Gear complete and Balance plate. (Fig. 28)

5. Assemble Crank complete to Gear housing. Push down Crank complete while turning it until the groove on

shaft of Gear housing can be seen. (Fig. 29)

6. While locking crank complete with 1R235, fasten Crank complete with two M4x12 Hex socket head bolts with

adhesive. (Fig. 30)

Note: Do not fasten Crank complete with the used M4x12 Hex socket head bolts. Use new M4x12 Hex socket head bolts

with adhesive. The fastening torque of these bolts has to be 2.4 - 3.5 N.m.

7. Install Retaining ring S-8 to the groove on the shaft of Gear housing using 1R291 to secure the components. (Fig. 31)

Fig. 26

Shaft of Gear housing

Flat

washer 8

Fig. 29

Groove on the shaft of Gear housing

for Retaining ring S-8

Crank complete

Press down Crank complete until the groove

on the shaft of Gear housing can be seen.

Fig. 31

Retaining ring S-8

Fig. 27

Shaft of Gear housing

Push plate

Seal plate

Gear housing

Fig. 30

Balance plate

Crank complete

Balance plate

Gear complete

Push plate

Flat washer 8

Seal plate

Fig. 28

Balance

plate

Gear complete

M4x12 Hex socket head bolts

1R235

Retaining ring S-8

P 9 / 14

Shaft of Gear housing

Crank complete