Makita 5091DWH 사용 설명서 - 페이지 10

{카테고리_이름} Makita 5091DWH에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 5091DWH 18 페이지. 85 mm (3-3/8")
Makita 5091DWH에 대해서도 마찬가지입니다: 부품 목록 (2 페이지)

CAUTION:

.The fast charger Model DC1201

specifically designed t o charge only

Makita

battery

cartridges. Never use

for other purposes or for other manufacturer's batteries.

When you charge a new battery cartridge or a battery cartridge which has not been used

for a long period of time, it may not accept a full charge. This i s a normal condition and

does not indicate a problem. You can recharge the battery cartridge fully after discharg-

ing it completely and recharging

couple of times.

If you charge a battery cartridge from a just-operated tool or a battery cartridge which

has been left in a location exposed to direct sunlight or heat for a long time,

the

charg-

ing light may flash in red color. If this occurs, wait for a while. Charging will begin after

the battery cartridge cools. The battery cartridge will cool faster if you remove the

battery cartridge from the fast charger.

I f the charging light flashes alternately in green and red color and a tone sounds "beep,

beep, beep,

. .

for about 20 seconds, a problem exists and charging i s not possible.

The terminals on the charger or battery cartridge are clogged with dust

or the

battery

cartridge is worn out or damaged.

If you wish t o charge two battery cartridges, allow 15 minutes between chargings on the

fast charger.

Removing or installing the saw

blade

CAUTION :

Always be sure that the tool is switched off and the battery cartridge is removed before

installing or removing the blade.

To remove the blade, press the shaft lock

so that the blade cannot revolve and use

the hex wrench t o loosen the bolt counter-

clockwise. Then remove the bolt, outer

flange and blade.