Makita 5091DWH Instrukcja obsługi - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Elektronarzędzie Makita 5091DWH. Makita 5091DWH 18 stron. 85 mm (3-3/8")
Również dla Makita 5091DWH: Lista części (2 strony)
Drukuj stronę
CAUTION:
.The fast charger Model DC1201
is
specifically designed t o charge only
Makita
battery
cartridges. Never use
it
for other purposes or for other manufacturer's batteries.
When you charge a new battery cartridge or a battery cartridge which has not been used
for a long period of time, it may not accept a full charge. This i s a normal condition and
does not indicate a problem. You can recharge the battery cartridge fully after discharg-
ing it completely and recharging
a
couple of times.
0
If you charge a battery cartridge from a just-operated tool or a battery cartridge which
has been left in a location exposed to direct sunlight or heat for a long time,
the
charg-
ing light may flash in red color. If this occurs, wait for a while. Charging will begin after
the battery cartridge cools. The battery cartridge will cool faster if you remove the
battery cartridge from the fast charger.
0
I f the charging light flashes alternately in green and red color and a tone sounds "beep,
beep, beep,
. .
."
for about 20 seconds, a problem exists and charging i s not possible.
The terminals on the charger or battery cartridge are clogged with dust
or the
battery
cartridge is worn out or damaged.
0
If you wish t o charge two battery cartridges, allow 15 minutes between chargings on the
fast charger.
Removing or installing the saw
blade
CAUTION :
Always be sure that the tool is switched off and the battery cartridge is removed before
installing or removing the blade.
To remove the blade, press the shaft lock
so that the blade cannot revolve and use
the hex wrench t o loosen the bolt counter-
clockwise. Then remove the bolt, outer
flange and blade.
10