CORNING EDGE8-04U 설치 및 테스트 - 페이지 2
{카테고리_이름} CORNING EDGE8-04U에 대한 설치 및 테스트을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING EDGE8-04U 13 페이지. Tap module
CORNING EDGE8-04U에 대해서도 마찬가지입니다: 설치 및 테스트 (8 페이지)
페이지 인쇄
2.
Precautions
2.1
Laser Precautions
WARNING: DO NOT use magnifiers in the presence of laser radiation. Diffused laser light
can cause eye damage if focused with optical instruments. Should accidental eye exposure to
laser light be suspected, arrange for an eye examination immediately.
2.2
Cable Handling Precautions
CAUTION: Fiber optic cable is sensitive to excessive pulling, bending, and crushing forces.
Consult the cable specification sheet for the cable you are installing. Do not bend the cable
more sharply than the minimum recommended bend radius. Do not apply more pulling force
to the cable than specified. Do not crush the cable or allow it to kink. Doing so may cause
damage that can alter the transmission characteristics of the cable; the cable may have to be
replaced.
3.
Tools and Materials
3.1
The following tools and materials are required for this procedure:
•
Two (2) power meters with LC port adapters
•
Two (2) LC-LC jumpers
•
One (1) SC-LC jumper for the light source
•
Three (3) LC-LC single-mode adapters
•
Light source with SC port adapter
•
At least one MTP to LC harness with Universal Polarity Wiring (module pinning is outlined in
Section 1.1):
•
Multimode module harness:
•
•
•
Single-mode module harness:
•
•
•
LC connector and port cleaning tool (p/n CLEANER-PORT-LC)
•
MTP Connector and Port Cleaning Tool (p/n 2104466-01)
For multimode applications:
Use Reference Grade test jumpers, test jumpers with non-ClearCurve
flux-compatible test equipment.
•
Two (2) LC/SC jumpers
•
Two (2) LC/LC jumpers
•
Mandrel wrap suitable for testing 50 μm fiber
STANDARD RECOMMENDED PROCEDURE 003-139-AEN | ISSUE 1 | JANUARy 2017 | PAGE 2 OF 13
Pinned: P/N HE57908QPH-KB003F
Non-pinned: P/N HE67908QPH-KB003F
Pinned: P/N HE77808GPH-KB003F
Non-pinned: P/N HE87808GPH-KB003F
50 µm fiber, or encircled
®