CORNING Pretium EDGE ETM-7B-Q 설치 및 테스트 - 페이지 2

{카테고리_이름} CORNING Pretium EDGE ETM-7B-Q에 대한 설치 및 테스트을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING Pretium EDGE ETM-7B-Q 9 페이지. Tap module

Precautions

2.1

Laser Precautions

\WARNING: DO NOT use magnifiers in the presence of laser light - diffused laser light can cause eye

damage of focused with optical instruments. Never look directly into the end of a connector that may

be carrying laser light. Should accidental eye exposure to laser light be suspected, arrange for an eye

examination immediately

2.2

Cable Handling Precautions

NOTE:

Fiber optic cable is sensitive to excessive pulling, bending, and crushing forces. Do not bend

cables more sharply than their minimum recommended bend radius. Do not apply more pulling

force to the cable assembly than specified. Do not crush the cable or allow it to kink. Doing so may

cause damage that can alter the transmission characteristics of the cable; the cable may have to

be replaced.

3.1

The following tools and materials are required for this procedure:

• Two (2) power meters with LC port adapters

• Two (2) LC-LC jumpers

• One (1) SC-LC jumper for the light source

• One (1) LC-LC adapter

• Light source

• One MTP to LC harness

• LC port cleaner (p/n CLEANER-PORT-LC)

• MTP Connector and Port Cleaning Tool (p/n 2104466-01)

For multimode applications:

• Mandrel wrap suitable for your cable type (available in p/n OTS-COMBOMAN)

4.1

Cleaning the LC adapters with an LC port cleaner

before each mating is recommended (Figure 2).

4.2

The use of an MTP Connector and Port Cleaning

Tool to clean MTP connectors and ports before each

mating is recommended (Figure 3).

STANDARD RECOMMENDED PROCEDURE 003-126 | ISSUE 1 | OCTOBER 2012 | PAGE 2 OF 9

HPA-0738

HPA-0754

Figure 2

Figure 3