Makita 5477NB 사용 설명서 - 페이지 6

{카테고리_이름} Makita 5477NB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 5477NB 12 페이지. Hypoid saw 185mm (7-1/4")
Makita 5477NB에 대해서도 마찬가지입니다: 기술 정보 (8 페이지)

페이지 인쇄

27. Before setting the tool down after completing

a cut, be sure that the lower guard has closed

and the blade has come to a complete stop.

28. Never attempt to saw with the circular saw

held upside down in a vise. This is extremely

dangerous and can lead to serious accidents.

000029

29. Some material contains chemicals which may

be toxic. Take caution to prevent dust

inhalation and skin contact. Follow material

supplier safety data.

30. Do not stop the blades by lateral pressure on

the saw blade.

31. Always use blades recommended in this

manual. Do not use any abrasive wheels.

32. Keep blade sharp and clean. Gum and wood

pitch hardened on blades slows saw and

increases potential for kickback. Keep blade clean

by first removing it from tool, then cleaning it with

gum and pitch remover, hot water or kerosene.

Never use gasoline.

33. Wear a dust mask and hearing protection

when use the tool.

SAVE THESE INSTRUCTIONS.

WARNING:

DO NOT let comfort or familiarity with product

(gained from repeated use) replace strict adherence

to safety rules for the subject product. MISUSE or

failure to follow the safety rules stated in this

instruction manual may cause serious personal

injury.

FUNCTIONAL DESCRIPTION

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before adjusting or checking function on

the tool.

Adjusting depth of cut

009224

CAUTION:

After adjusting the depth of cut, always tighten the

•

lever securely.

Loosen the lever on the depth guide and move the base

up or down. At the desired depth of cut, secure the base

by tightening the lever.

For cleaner, safer cuts, set cut depth so that no more

than one blade tooth projects below workpiece. Using

proper cut depth helps to reduce potential for dangerous

KICKBACKS which can cause personal injury.

Bevel cutting

009225

Loosen the lever on the bevel scale plate on the front of

the base. Set for the desired angle (0° - 51.5°) by tilting

accordingly, then tighten the lever securely.

Use the 45° stopper when you do precise 45° angle

cutting. Turn the stopper counterclockwise fully for bevel

cut (0° - 45°) and turn it clockwise for 0° - 51.5° bevel

cuts.

1. Lever

1. Bevel scale plate

2. Lever