Makita 5477NB 사용 설명서 - 페이지 7

{카테고리_이름} Makita 5477NB에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 5477NB 12 페이지. Hypoid saw 185mm (7-1/4")
Makita 5477NB에 대해서도 마찬가지입니다: 기술 정보 (8 페이지)

페이지 인쇄

0-45°

009226

Sighting

009227

For straight cuts, align the A position on the front of the

base with your cutting line. For 45° bevel cuts, align the B

position with it.

Switch action

009228

CAUTION:

Before plugging in the tool, always check to see

•

that the switch trigger actuates properly and returns

to the "OFF" position when released.

To start the tool, simply pull the switch trigger. Release

the switch trigger to stop.

ASSEMBLY

CAUTION:

Always be sure that the tool is switched off and

•

unplugged before carrying out any work on the tool.

1. Stopper

0-51.5°

1. Base

1. Switch trigger

Hex wrench storage

009327

Hex wrench is stored on the tool. To remove hex wrench,

rotate it toward yourself and pull it out.

To install hex wrench, place it on the grip and turn it until it

comes into contact with the protrusion on the grip.

Removing or installing saw blade

009229

CAUTION:

Be sure the blade is installed with teeth pointing up

•

at the front of the tool.

Use only the Makita hex wrench to install or remove

•

the blade.

To remove the blade, press the shaft lock so that the

blade cannot revolve and use the hex wrench to loosen

the hex bolt clockwise. Then remove the hex bolt, outer

flange and blade.

To install the blade, follow the removal procedure in

reverse. BE SURE TO TIGHTEN THE HEX BOLT

COUNTERCLOCKWISE SECURELY.

009230

When changing blade, make sure to also clean upper

and lower blade guards of accumulated sawdust. Such

efforts do not, however, replace the need to check lower

guard operation before each use.

1. Grip

2. Hex wrench

1. Shaft lock

2. Hex wrench

1. Ring 17

2. Inner flange

3. Saw blade

4. Outer flange

5. Hex bolt