Makita 5477NB 기술 정보 - 페이지 6

{카테고리_이름} Makita 5477NB에 대한 기술 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 5477NB 8 페이지. Hypoid saw 185mm (7-1/4")
Makita 5477NB에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지)

페이지 인쇄

epair

[6] DISASSEMBLY/ ASSEMBLY OF ARMATURE SECTION

DISASSEMBLING

Note: It is not necessary to remove Bearing box from Gear housing complete when replacing Armature.

1) Separate Base from Motor section. (Figs 2 to 5)

2) After Removing Depth guide from Motor housing complete, remove Carbon brush.

3) Separate Gear housing complete from Motor housing complete after removing M5x35 Pan head screws (4pcs.).

(Figs. 9, 12, 14 and 15)

4) Remove Armature section upward from Gear housing complete while holding Gear housing complete with Armature

section positioned in Fig. 20L.

Note: Do not remove Armature section downward and horizontally from Gear housing complete (Fig. 20R).

Because Gear oil remaining inside is drained out from Gear housing complete.

5) Remove Retaining ring S-17 using 1R291. (Fig. 21)

6) Remove Ball bearing 6003LLB, O ring 16 and Ring 17 using 1R269 and water pump pliers. (Fig. 22)

7) Bearing retainer can be removed from Armature. (Fig. 23)

Fig. 20L

Correct

M5x18 Pan head screw

Fig. 22

Ball bearing 6003LLB

O ring 16

Note: O ring 16 has to be replaced with new one

whenever Ball bearing 6003LLB is removed.

Fig. 20R

Wrong

M5x18 Pan head screw

Gear oil

Note: Be careful not to scratch

its surface where Oil seal 22

contacts.

Ring 17

Water pump pliers with which

the legs of 1R269 are clamped.

Fig. 21

Retaining ring S-17

1R269

P 6/ 8

1R291

Fig. 23

Bearing retainer