CORNING UAT3 사용 설명서

{카테고리_이름} CORNING UAT3에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING UAT3 18 페이지.

Universal Access Tool 3

Operating Instructions

P/N 004-074

Issue 12

General

1.1

The Corning Optical Communications Universal Access Tool 3

(UAT3) is designed to access individual fibers or ribbons in single tube

cables in a mid-span location (Figure 1). The tool, Corning part number

UAT3-000, is designed to access fibers in buffer tubes from 5 to 24 mm

in outer diameter (OD).

1.2

This procedure describes the use of the access tool and

illustrates how to access fibers or ribbons in Corning Optical

Communications single tube ribbon, stranded loose tube ribbon, and

single tube (loose or bundled fiber) cable designs (see Table 1).

NOTE: Other manufacturer's tubes may require blade adjustment

derived through experimental cuts on scrap tube sections.

1.3

The UAT3 tool is designed to give infinite blade height

adjustment to accommodate a range of both tube diameter and wall

thickness. This is accomplished without the need for a set-up gauge

through the use of both coarse and fine adjustment wheels on both

halves of the tool (Figure 2).

Standard Recommended Procedure 004-074 | Issue 12 | May 2017 | Page 1 of 18

Figure 1