CORNING UAT3 사용 설명서 - 페이지 6

{카테고리_이름} CORNING UAT3에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CORNING UAT3 18 페이지.

4.3

To ground armored cables, remove the outer sheath and

armor between the tape marks following the cable manufacturer's

instructions.

CAUTION: Never permit the UAT3 tool to contact the cable

armor, as blade or tool damage may result.

4.4

Access the cable's buffer tube according to the appropriate

sheath removal procedure.

4.5

Place a mark 12.5 cm (5 in) (or as required for the terminal you

are installing) from the end of each side of the exposed section of

buffer tube with a permanent marking pen (Figure 4).

4.6

Depending upon the type of closure or terminal being used,

assembly may be easier if you install cable mounting hardware and

sealants at this time.

For an SCN closure, install the sheath retaining clamps and sealing tape

before proceeding to Section 8 (Figure 5).

Tool Preparation and Initial

Adjustment

5.1

Before each use, check the blades for dullness or damage. If

necessary, replace the blades per Section 10 of this manual.

5.2

To attach the tool's handle , hold the drive shaft with the 3/8-in

wrench provided and thread the handle onto the shaft (Figure 6).

Sealing tape

tube

Sheath retention clamps

Standard Recommended Procedure 004-074 | Issue 12 | May 2017 | Page 6 of 18

Figure 4

Figure 5