Makita 6911HD 사용 설명서 - 페이지 5

{카테고리_이름} Makita 6911HD에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6911HD 17 페이지. Cordless impact wrench
Makita 6911HD에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지), 사용 설명서 (10 페이지), 사용 설명서 (16 페이지)

페이지 인쇄

1. Specifications

SYMBOLS

The followings show the symbols used for tool.

V ....................... volts

................... direct current

................... no load speed

IMPORTANT SAFETY INSTRUCTIONS FOR

CHARGER & BATTERY CARTRIDGE

1. SAVE THESE INSTRUCTIONS - This man-

ual contains important safety and operat-

ing instructions for battery charger.

2. Before using battery charger, read all

instructions and cautionary markings on

(1) battery charger, (2) battery, and (3)

product using battery.

3. CAUTION - To reduce risk of injury, charge

only

MAKITA

marked on the charger label. Other types

of batteries may burst causing personal

injury and damage.

4. Do not expose charger to rain or snow.

5. Use of an attachment not recommended

or sold by the battery charger manufac-

turer may result in a risk of fire, electric

shock, or injury to persons.

Table 1: RECOMMENDED MINIMUM AWG SIZE FOR EXTENSION CORDS FOR BATTERY CHARGERS

Length of Cord (Feet)

AWG Size of Cord

9. Do not operate charger with damaged

cord or plug - replace them immediately.

rechargeable

batteries

.../min................revolutions or reciprocation per

................number of blow

6. To reduce risk of damage to electric plug

and cord, pull by plug rather than cord

when disconnecting charger.

7. Make sure cord is located so that it will

not be stepped on, tripped over, or other-

wise subjected to damage or stress.

8. An extension cord should not be used

unless absolutely necessary. Use of

improper extension cord could result in a

risk of fire and electric shock. If extension

cord must be used, make sure:

a. That pins on plug of extension cord

are the same number, size, and shape

as those of plug on charger;

b. That extension cord is properly wired

and in good electrical condition;

c. That wire size is at least as large as

the one specified in the table below.

10. Do not operate charger if it has received a

sharp blow, been dropped, or otherwise

damaged in any way; take it to a qualified

serviceman.

minute

100

USD302-1

USC001-3

150