Makita 6911HD 사용 설명서 - 페이지 7

{카테고리_이름} Makita 6911HD에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita 6911HD 17 페이지. Cordless impact wrench
Makita 6911HD에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지), 사용 설명서 (10 페이지), 사용 설명서 (16 페이지)

페이지 인쇄
Makita 6911HD 사용 설명서
FUNCTIONAL
DESCRIPTION
1
2
1. Set plate
2. Battery cartridge
1
2
1. Battery cartridge
2. Charging light
3. Battery charger
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before adjusting or
checking function on the tool.

Installing or removing battery cartridge

002302
•
Always switch off the tool before insertion or removal of
the battery cartridge.
•
To remove the battery cartridge, pull out the set plate on
the tool and grasp both sides of the cartridge while
withdrawing it from the tool.
•
To insert the battery cartridge, align the tongue on the
battery cartridge with the groove in the housing and slip
it into place. Snap the set plate back into place. Be sure
to close the set plate fully before using the tool to prevent
the battery cartridge from accidentally falling out of the
tool.
•
Do not use force when inserting the battery cartridge. If
the cartridge does not slide in easily, it is not being
inserted correctly.
Charging
004545
1. Plug the battery charger into the proper AC voltage
source. The charging light will flash in green color.
3
2. Insert the battery cartridge so that the plus and minus
terminals on the battery cartridge are on the same sides
as their respective markings on the charger. Insert the
cartridge fully into the port so that it rests on the charger
port floor.
3. When the battery cartridge is inserted, the charging light
color will change from green to red and charging will
begin. The charging light will remain lit steadily during
charging.
4. When the charging light color changes from red to
green, the charging cycle is complete.
5. If you leave the battery cartridge in the charger after the
charging cycle is complete, the charger will switch into
its "trickle charge (maintenance charge)" mode.
6. After charging, unplug the charger from the power
source.
7