Gardasoft Vision PP860 사용자 설명서 - 페이지 13
{카테고리_이름} Gardasoft Vision PP860에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gardasoft Vision PP860 17 페이지. Led lighting controller
페이지 인쇄10.1.1
General Commands
AW Save the settings to memory.
Syntax:
AW
Once the settings are saved to memory they are then retained when the
unit is switched off. If this is not done, changes to the settings are volatile,
and if the unit is switched off they revert to those in force when the last
AW command was issued.
Report the current settings for the outputs
ST
Syntax:
ST
The first four lines of the response report the output settings. The format
is either:
f M m V a
f M m C a D d P p
Where:
f
output channel
m is one of:
0
Not set up
1
Pulsed output
2
Continuous output
a
Output current (amps)
p
Pulse width (microseconds)
d
Delay before pulse (microseconds)
VR Report the version of firmware running in the PP860
Syntax:
VR
Response:
version
10.1.2
Continuous Output Mode
In this case the mode of operation is selected and a single current output value
defined.
Set continuous operation
RS
Syntax:
RSf,a
Where:
f = output channel (0 to 7)
a = output current (A)
Example of Continuous Output Mode
13
For Constant Mode
For Pulsed Output Mode