ALIBI ALI-NVR3108 빠른 설정 매뉴얼 - 페이지 8
{카테고리_이름} ALIBI ALI-NVR3108에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALIBI ALI-NVR3108 12 페이지.
페이지 인쇄- 1. Step 2. NVR Installation General Guidelines
- 2. Installing the System
- 3. Step 3. Install a Monitor, Mouse, Power
- 4. Step 4. Connecting It Together - Initial System Setup
- 5. Step 5. Using the Wizard for Basic Configuration Setup
- 6. Step 6. Access the Menu System
- 7. Specifications
- 8. HDD Installation
3.
The photo below shows the inside of the recorder without an HDD. Become familiar with the items identified in the photo.
PC board
HDD power cable
HDD SATA cable
Front panel cables
If your recorder was received without an HDD installed, the HDD power cable and SATA cable may or may not be plugged into the PC
board.
4.
Unpackage the HDD you are installing in the chassis, and then place it underside up on a clean, electrostatic-free surface. Follow the
ESD guidelines described above.
8
www.Observint.com
Back
Holes and slots for
HDD screws
Front
5.
Screw the four HDD mounting screws provided into the holes on the underside of the HDD until the screw heads are about
1/8 inch above the surface.
6.
Position the HDD in the recorder chassis with the HDD mounting screws fully seated in the holes and slots in the bottom of the chassis.
The HDD should be above the front panel ribbon cable, and under the front panel black cable. See the photo above for the location of
these cables.
7.
While holding the HDD in place in the chassis, turn the chassis over, and then ensure that the mounting screws are fully seated in the
mounting screw slots as shown in the photo below. Tighten the HDD mounting screws until snug. Be careful to not over-tighten the
screws.
HDD mounting
screw holes
© 2015 Observint Technologies. All rights reserved.