ALIBI ALI-NVR3108 빠른 설정 매뉴얼 - 페이지 9

{카테고리_이름} ALIBI ALI-NVR3108에 대한 빠른 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ALIBI ALI-NVR3108 12 페이지.

Turn the chassis over, and then attach the HDD power cable and SATA cable to the mating connectors on the HDD and PC board. These

connectors must be fully seated.

Reinstall the DVR cover using the cover using the screws removed earlier.

10.

During the DVR initialization, follow the options in the Wizard to initialize/reformat the HDD. You can also initialize the HDD using

the Menu | HDD feature. For more information, refer to the ALIBI Embedded Network Video Recorder Firmware V3.3.4 User

Manual available for download from your vendor.

www.Observint.com

11.

Initialize (Init) the HDD when you setup the NVR using Wizard.

HDD Installation - ALI-NVR3108P - HDD 1

The recorder will accommodate one or two internal HDDs. If your recorder doesn't have an HDD installed, use this procedure to install the first

HDD. The HDD mounting screws and HDD cables are provided with your recorder.

Follow recommended electrostatic discharge (ESD) guidelines while performing this procedure. Install the HDD in a static-free

environment, wearing a certified ESD wrist strap. If a static free environment and ESD wrist strap is not available, touch the bare



metal of the DVR chassis frequently when installing the drive to dissipate the static charge naturally generated on your skin and

CAUTION

clothing and avoid touching electronic components.

Disconnect all cables from the recorder, and then set the recorder on a clean, static free surface, top up.

Remove the top cover from the recorder by removing the cover screws on the back of the chassis, and each side.

Orient the chassis as shown in the picture below. Become familiar with the locations of the HDD mounting screws for HDD 1 (initial

HDD) and HDD 2 (second HDD), and the location of the HDD 1 SATA connector on the PC board.