Makita DA4030 사용 설명서 - 페이지 9
{카테고리_이름} Makita DA4030에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Makita DA4030 17 페이지. Angle drill
Makita DA4030에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 사용 설명서 (8 페이지), 사용 설명서 (10 페이지)
페이지 인쇄
1
1. Spade grip
2. Wrench holder
3. Hex wrench
1. Chuck key
Spade grip
003042
2
The spade grip can be installed in any position as shown in
the figure. To change the position, loosen the hex bolts (both
sides) with a hex wrench and turn the spade grip to the
desired position. Then tighten the hex bolts securely. After
reposition the grip, return the hex wrench to the wrench
3
holder.
CAUTION:
•
Do not fix the spade grip beyond the limits of the arrow.
Be cautious that your hand is not caught in the grip.
003043
Keep the hand away from the drill chuck. They can lead
to serious accidents.
•
Always be sure that the hex bolts (both sides) of the
spade grip are tightened securely.
Installing or removing drill bit
003054
To install the bit, place it in the chuck as far as it will go.
Tighten the chuck by hand. Place the chuck key in each of
the three holes and tighten clockwise. Be sure to tighten all
three chuck holes evenly.
To remove the bit, turn the chuck key counterclockwise in just
one hole, then loosen the chuck by hand.
1
After using the chuck key, be sure to return to the original
position.
9