Avantik QS11 빠른 참조 매뉴얼 - 페이지 2

{카테고리_이름} Avantik QS11에 대한 빠른 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Avantik QS11 2 페이지.

QS11 Operator Notes

•

Sectioning – The recommended blade holder angle for most applications is 10°

•

After each use – Remove any debris from the microtome and cryo-chamber. Especially

clean the blade holder, specimen head and vertical travel areas. A build-up of debris

over time may freeze causing "knocking" or "thumping" during handwheel operation.

•

Periodically – Empty the liquid that accumulates in the plastic container from the defrost

cycles. The container should be periodically disinfected.

•

Defrosting – Due to the extremely low temperature in the cryo-chamber and the window

remaining open for extended periods of time during operation, humidity from the room

will create a frost build-up inside the cryostat. It may be necessary to occasionally turn

the cryostat off and perform a complete defrost of the unit.

QS11 Troubleshooting Guide

Issue

Error 1

Error 2

Error 3

Error 4

"H" Codes

Keypad unresponsive

* Warning: The cabinet and microtome must be entirely dry before cooling down the cryostat.

Any moisture inside or outside the microtome will freeze. This may result in a malfunction or

possible damage to the instrument.

Remedy

Electronics issue – contact technical assistance

Software backup battery needs to be replaced

Cabinet temperature is above 0°C. Confirm the microtome is dry*. Press the

"Memo" button to proceed

Confirm the cable to the microtome is properly connected

This is not an error but an indication that the cryostat is in a defrost cycle

A power failure occurred. Turn the main power switch off, wait 30 seconds and

restart the cryostat. Confirm the cabinet temperature is below 0°C and that the

microtome is dry*.

Avantik Technical Assistance: 1-800-783-9424