Corsa 14866BLK 설치 지침 매뉴얼 - 페이지 2

{카테고리_이름} Corsa 14866BLK에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Corsa 14866BLK 6 페이지. Cat back exhaust system for chevrolet silverado 2014; chevrolet silverado 2015; chevrolet silverado 2016; chevrolet silverado 2017; gmc sierra 1500 2014; gmc sierra 1500 2015; gmc sierra 1500 2016; gmc sierra 1500 2017

페이지 인쇄

Factory Exhaust System Removal:

1. Beginning near the flex section, loosen the clamp using the ratchet and 13mm deep socket. (Fig A)

Note: Penetrating lubricant may make this step easier.

2. Downstream of the flex section, remove the hanger from the rubber grommet using grommet pullers or a

similar device. (Fig B)

Note: A soap and water solution may aid in the removal of hangers.

3. Support the front portion of the exhaust system (just in front of the muffler) using a jack stand or similar device.

4. Remove the two hangers from the rubber grommets downstream of the muffler using grommet pullers or a

similar device. (Fig C)

Note: At this point, the exhaust is only supported by the jack stand and the hanger near the tip. Take care to not

let the exhaust system tip or roll as it may damage the vehicle and/or cause personal injury.

5. Using the grommet pullers, remove the last hanger near the tip. (Fig D)

6. Carefully remove the factory exhaust system from the vehicle by first twisting the system within the chassis and

pushing it backwards to clear the chassis bracing at the front and then pulling the exhaust system forward.

Note: Take care to not damage the brake lines or wires near the rear axle when moving the exhaust system. If

you are not able to move the system rearward enough to clear the chassis bracing near the front of the factory

exhaust, cutting the factory exhaust system will be required. We suggest cutting the exhaust in front of the

tunnel muffler using chain-style pipe cutters or a similar device.

7. Using a small, flathead screwdriver or similar device, gently pry the retaining tab just enough to remove

spherical clamp from the factory exhaust system. (Fig E) Keep the clamp for later use during installation of the

Corsa exhaust.

8. This concludes the factory exhaust system removal process.

Cat Back Exhaust System

Single Side Exit w/ Twin 4.5" Pro-Series Tips

2014+ Chevrolet Silverado/GMC Sierra 1500 6.2L

143.5" & 153" Wheel Base

PN: 14866, 14866BLK