GARDEN MASTER GM2308 조립 지침 매뉴얼 - 페이지 3
{카테고리_이름} GARDEN MASTER GM2308에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GARDEN MASTER GM2308 8 페이지. Sloping roof shed
페이지 인쇄
STEP 1:
FRONT WALL
1.
Slip
780mm wide sheet with door jamb under door. Use
D
determine the correct opening size by placing on the bottom flange of the door
jambs. Then rivet
G
2.
Outside: Rivet channel at corners and every 2nd rib between and through door
jambs and spacer.
3.
Inside: One rivet per sheet at each end up through channel underside and
through door jambs and spacer.
Rivet padbolt to the outside of door using wide flange rivets supplied.
A Door jamb fits inside bottom channel.
B Door spacer fits inside door jamb but
A
B
keeper
washer
Rivet
Padlock keeper assembly
SCAN TO
WATCH OUR
ASSEMBLY VIDEO
HERE
FITTING CHANNELS
The higher side of the channel goes to the
inside of the shed. It is very important to
include the rivets on the underside of all the
channels as they are structural
(except roof channels).
OUTSIDE
!
If you choose to vary from these instructions your
warranty will be impaired.
channels to tops and bottoms of sheeting.
to the outside of bottom channel.
D
I
G
CHANNELS WITH CUTOUTS
The cutouts go to the inside of the panel to
allow easy fitment of the end walls
on assembly.
INSIDE
door spacer to
I
Channels will come short of the ends of the
sheeting by 10-15mm on all panels.
E
B Drill through to the underside.
Rivet top and underside.
TOP
BOTTOM
i
If you need advice, call us
or email us at [email protected]
YOU WILL NEED:
1 x 780mm wide sheet with
D
door jamb attached
Door pre-hinged to 700mm
E
sheet with door jamb
1 x 2255mm top channel
G
1 x 2255mm bottom channel
I
2 x 793mm door spacers
G
I
A Drill and rivet here.
A
GARDEN MASTER TIP
To hinge the door on the opposite side,
simply put the top channel on the
bottom and the bottom on the top.
Put the padbolt on the door before
erecting the panels. It will stop the
door swinging around!
FREE
0800 807 433
on
B
3