GARDEN MASTER GM2308 조립 지침 매뉴얼 - 페이지 4
{카테고리_이름} GARDEN MASTER GM2308에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. GARDEN MASTER GM2308 8 페이지. Sloping roof shed
페이지 인쇄
STEP 2:
BACK WALL
1.
Join 3
sheets together with 2 rivets through the overlapping ribs
A
making sure the ends of the sheets are flush.
2.
Cap sheeting with
G
same as the front wall.
3.
Rivet the channels through the end ribs and every 2nd rib between.
4.
Make sure you put at least 1 rivet per sheet up through the
underside of the channel into the pan of the sheet.
GARDEN MASTER TIP
Put extra rivets in for high wind areas,
particularly on the underside.
STEP 3:
ROOF
1.
Join 3
980mm sheets together, same as the back.
C
2.
Cap sheeting with
F
3.
Rivet the channels at every second rib but not the corners at this stage.
4.
Place the short flange of the 'L' on top of the rib at one end. Make sure ends are
flush with sheeting (diagram 4) and put one rivet in the centre to hold the 'L'.
Rivet the corners through the channels and one more between the corner
and the centre rivet. Perform the same at the other end.
5 rivets for each 'L'.
!
4
channels putting the cutouts top and bottom
G
2255mm channels.
F
DIAGRAM 4
If you choose to vary from these instructions your
warranty will be impaired.
A
H
C
i
YOU WILL NEED:
A
3 x 1770mm sheets for the back
1 x 2255mm top channel
G
1 x 2255mm bottom channel
G
YOU WILL NEED:
C
3 x 980mm long sheets
F
2 x 2255mm channels
H
2 x 980mm 'L's
F
If you need advice, call us
FREE
or email us at [email protected]
SCAN TO
WATCH OUR
ASSEMBLY VIDEO
HERE
H
on
0800 807 433